Magic Drip DM8 High Performance Silicone Flange Sealant

·Good resistance to oil and joint movement

·Can be supplied in cartridges, tubes or rocep cans

·For use with flexible flanges

·Reduces migration of liquid after application

·Import Vehicles

·Intake Manifolds

·Transmission Pans

·Oil Pans

·Timing Gear Covers

·Cam Covers

·Automotive

For best results, clean and dry all surfaces.

Cut nozzle to desired bead size. Gaskets are best formed using a 1/16” to 1/4” bead.

Apply a continuous, even bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. Allow to dry for one hour then retighten 1/4 to 1/2 turn.

Silicone will skin over in one hour and fully cure in 24 hours under normal conditions. Allow more time for cold or very dry conditions.

Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 to 28C (46 to 82F) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused product, do not return any material to its original container.